LM3916 is a dedicated IC for VU LED meter. Unlike LM3915 which have 3dB step between voltage levels, the LM3916 have nonlinear steps: -20, -10, -7, -5, -3, -1, 0, +1, +2, +3db, just like old school analog VU meters.
The LM3916 can be feed with AC signal without any rectification, it implement a precision full wave rectification.
The LEDs are connected via sockets J3 to J12 (only one row LEDs is shown on the schematic).
The schematic needs bipolar power supply to work correctly, but the negative rail can be as low as -5V or even -3.3V. The positive rail must be bellow +25V and combined voltage of negative and positive rails must not exceed 36V. The minimum positive rail voltage depends on the voltage of the LEDs. For example if the LED have 1.9V forward voltage and we have 7 LEDs on one pin, then the minimum positive voltage will be 7*1.9V + 1.5V (drop voltage at LM3916) = 14.8V. The green LEDs usually have little higher forward voltage - 2.2V - 2.4V, so +18V will be sufficient in most cases.
The LEDs current is determined by R1_REF, and with 2.2k resistance it will be 5 - 6 mA.
The formula is Iled = 10 * (1.2V / R1_REF).
IC2 is connected as precision full wave rectifier and can be any general purpose dual op-amp - TL072, TL082, LF353.
The output mode can be set with 3-pin jumper JP1. Shorting pins 1-2 will set the bar mode and shorting pins 2-3 will set the dot mode.
The max input voltage of the LM3916 is set to 1.2V, and with R8-R7 we can adjust the input level.
The color of the LEDs is your choice. I used green LEDs for negative levels, yellow for 0dB and red for positive levels. For this project I bought transparent rectangular LEDs, but they have two drawbacks. First - when one column lights up the adjacent columns also significantly lights up. My solution was to paint the sides of the LEDs with black marker. There also can be used a black tape around the entire collumn.
Second drawback is that because of the transparency, the LEDs emit light from one point, which is not very pleasant. The solution here was to rasp the top side of the LEDs with rough file, so the light to diffuse more even.
Circuit Diagram
Related Posts
- Electronics Projects/Circuits29 May 20150
Seven Segment Intruder Alarm Circuit Speed Checker for Highways Sensitive Intruder Alarm Circuit...Read more »
- Speed Checker for Highways19 May 20150
While driving on highways, motorists should not exceed the maximum speed limit permitted for their...Read more »
- LM2585 12V to 24V at 1A Step-Up Switching Regulator05 Apr 20150
Description This is a DC-DC step-up converter based on LM2585-ADJ regulator manufactured by Tex...Read more »
- 400VA AC Light Dimmer05 Apr 20150
Description This is a simple TRIAC AC load dimmer used to control the power of a resistive load...Read more »
- PicoBuck - RGB LED Driver15 Mar 20150
The PicoBuck is a small and inexpensive 3-channel LED driver. It employs constant-current buck dri...Read more »
- LED Chaser Circuit15 Mar 20150
The led chaser is build on a perfboard using 10 leds, CD4017 decade counter, a 555 timer configure...Read more »
Subscribe to:
Post Comments (Atom)
Post a Comment
Click to see the code!
To insert emoticon you must added at least one space before the code.